Sales Rank: 4925


Features:

Brushed 18/8 stainless steel

14-1/4 inches high, 7-3/4-inch base

Knob on top screws to hold paper-towel roll in place

4-1/2-inch arm keeps roll from unwinding

Rubber pads under base prevent scratches

Average Rating:
Rating: - Good lookin Till you get it home
I was happy with the sleek look - but unfortunately it's kind of cheaply made. The vertical rods that keep the paper towel in place are loose and bending and no way to tighten at all! Nice looking until you use it, then kind of cheesy. There is acutally the same looking one at Macy's (I have only seen it in-store) and the vertical rod is not loose its very tight, very well made and....inexpensive!!

---

Rating: - Don't unscrew the knob . . .
For the most part I really like this paper towel holder. It's sturdy enough for me, but I must not be yanking off the towels as hard as everybody else apparently is. I would suggest not unscrewing the top to change the roll, as it is not a simple task to put it back together. The knob and rod are actually two or three pieces, not one as you would think. Anyway, I've found that you can just pull the empty roll up over the knob and replace it the same way, without unscrewing the top. It's actually easier than screwing around (hah!) with the knob.

---

Rating: - Industrial-looking but not industrial strength!
I was happy with the sleek look - but unfortunately it's kind of cheap-O. The vertical rods that keep the paper towel in place are loose and bending - and really no way to tighten! Nice looking until you use it, then kind of cheesy. The quest for a decent paper-towel holder continues, I'm afraid..